Info legali

When you visit any website, it may store or retrieve information on your browser, mostly in the form of 'cookies'. This information, which might be about you, your preferences, or your internet device (computer, tablet or mobile), is mostly used to make the site work as you expect it to. You can find out more about how we use cookies on this site, and prevent the setting of non-essential cookies, by clicking on the different category headings below. However, if you do this then it may impact your experience of the site and the services we are able to offer.

TTP223B Digital Touch Sensor Switch Module For Arduino


New product

TTP223B Digital Touch Sensor Switch Module For Arduino

More details

4 Items

In Stock

No reward points for this product.

3,00 €

More info

TTP223B Digital Touch Sensor Switch Module For Arduino


This is jog type capacitive touch switch sensor module based on a touch detection IC TTP223B. Normally, the output is low level(at mode of low power consumption). When the finger touch the corresponding location, output will be high(at quick speed mode). When the module do not be touched for 12 seconds, the mode would switch to low-power mode. It can be installed in the module, such as plastic, glass, non-metallic material surface. But not cover thin sheets(metal) on the surface of the module. Just touch the correct position, it can be hidden in walls, desktops and other parts to be buttons. Allows you to remove the troubles of conventional push-type buttons.


Low power consumption
Can replace the traditional key
With four M2 screw holes, easy for operation


Operating voltage: DC 2.0V ~ 5.5V
Sink current: 8mA @ VCC = 3V, VOL = 0.6V
Source current: -4mA @ VCC = 3V, VOH = 2.4V
Response time: 220ms (at mode of low power consumption) and 60ms (at quick speed mode)
Size: 24 x 24 x 7.2mm

Package included:

1 x Capacitive jpg type touch sensor module

Customers who bought this product also bought:

30 other products in the same category: