Info legali

When you visit any website, it may store or retrieve information on your browser, mostly in the form of 'cookies'. This information, which might be about you, your preferences, or your internet device (computer, tablet or mobile), is mostly used to make the site work as you expect it to. You can find out more about how we use cookies on this site, and prevent the setting of non-essential cookies, by clicking on the different category headings below. However, if you do this then it may impact your experience of the site and the services we are able to offer.

Sale! Arduino UNO REV3 with microcontroller ATmega328 100% Compatible View larger

Online only

9V 1A DC Power supply adapter for Arduino


New product

14 Items

No reward points for this product.

4,00 €

Data sheet

Height (inches)50 mm
Width100 mm
thickness (mil)10 mm
Weight (Oz)25 g
Temperature-10℃ ~ + 50 ℃
Output Voltage9 V
Input VoltageAC 100-240 V
Output current1 A
Aging test100% load aging
Storage temperature-20℃~+85℃

More info

9V 1A DC Power supply adapter for Arduino

Often get questions about the different ways to power Arduino (from PC, a power supply, a battery, etc.) and how to connect to our source of energy to our board.

As for Arduino Uno keep in mind that its core (ATmega328) operates at a voltage of between 4.5 and 5.5 volts (can be up to 6 volts, but I strongly advise against), while the maximum current that can pass (incoming or outgoing ) by a single pin it is 40 mA.
The maximum current that can switch between pin Vcc or Gnd is 200 mA (do the sum of the currents entering and leaving the pin).

Apart from the use of the USB cable, as an alternative power source we can also use the connector, the required voltage must be between 7 and 12 Volt and this product is for you but you can also use it to power another.


Customers who bought this product also bought:

16 other products in the same category: